Installing a New Disposal. Ooad Lab Manual For Library Management System there. Large channel- lock pliers or a pipe wrench work well to loosen the nuts holding the pipes together.

When both connections are free, remove the parts. You may want to clean the horizontal drain pipe to eliminate any possible blockage. When both connections are free, remove the parts.

Remove the strainer body. Using a flathead screwdriver, loosen the 3 screws on the mounting assembly and pry off the snap ring.

• Enjoy great-tasting fresh filtered water on-tap. Easy-to-install systems no separate tap needed. Quality water filters made in USA & assembled in Australia.
• Drilling a hole through your external wall. If you're installing a new tap you need to bore a hole through your outside wall for the connecting pipework.

Clean off the old plumber's putty that surrounds the edge of the drain opening. How To Edit Mde Database Design. Place a 1/2. Drop the new sink flange into the drain opening and press it into place. Placing a weight, such as your disposal, on top of the sink flange will help hold the sink flange in place while mounting it to the sink. To avoid scratching your sink or the flange, place a towel between the sink surface and the weight.

Hold these pieces in place. Next, slip on the mounting ring and snap ring. Tighten the three mounting screws, alternately tightening each screw a few turns at a time until the mounting assembly is evenly and tightly seated against the bottom of the sink. If using a dishwasher, you will need to tap out the dishwasher knockout plug. Lay the disposal on its side and use a screwdriver and hammer to tap it out. Next, remove the loose knockout plug from inside the disposal.

With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts. How it Works » New Instructable ».

Make sure the circuit breaker is off. Remove the plate on the bottom of the disposal to expose the wiring and use wire nuts to connect the wires from the disposal to the matching wires from the power supply. Finally, secure the power cord to the bottom of the disposal using the proper connection. Replace the plate to cover the wires.